Scheppach WTS2000 - Maintenance Plan; Troubleshooting

www.scheppach.com
32
|
GB
18. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault Possible cause Remedy
Motor does not work.
Engine, cable or
connector defective,
mains fuses blown.
Arrange for inspection of the product by a specialist.
Never repair the motor yourself. Danger!
Check mains fuses and replace as necessary.
The engine runs slowly
and does not reach the
operating speed.
Voltage too low, coils
damaged,
Capacitor blown.
Contact the utility provider to check the voltage.
Arrange for inspection of the motor by a specialist.
Arrange for replacement of the capacitor by a
specialist.
Engine producing
excessive noise.
Coils damaged, motor
defective.
Arrange for inspection of the motor by a specialist.
The motor does not reach
its full power.
Power circuits in mains
system overloaded (lamps,
other engines, etc.).
Do not use any other products or motors on the same
circuit.
Motor overheats easily.
overloading of the motor,
insu󰀩cient cooling
of the engine.
Avoid overloading the motor while cutting, remove dust
from the motor in order to ensure optimal cooling of the
motor.
19. Maintenance plan
Before every use
after operating for 10
hours
Clean guide rails X
lubricate guide rails with non-dirt-binding grease X
Visual inspection of the product X
Exchange water X
Cleaning the product X
Check mains cable X
Change diamond cutting disc Immediately, if defective or worn