Schlage AD-402 - Reset to Factory Default Settings; Level 1 Factory Default Reset; Level 2 Factory Default Reset

10 • Schlage • AD-400 user guide
Reset to factory default settings
L All information in the lock will be deleted and reset to factory defaults!
Level 1 factory default reset
L Level 1 factory default reset will delete congurations and settings in the main
controller in the lock.
L Level 1 factory default reset will not reset congurations and settings in the
reader.
1. Remove the top inside cover.
2. Press and hold the Schlage button until two (2) beeps sound (10 seconds).
3. Release the Schlage button.
4. Press and release the inside push button (IPB) three (3) times within 10 seconds. One
beep will sound and one red blink will occur with each press.
5. The Schlage button and IPB will both light green for one second and a one-second beep
will sound to conrm that the lock has been reset.
L If IPB is not pressed 3 times within 10 seconds, two beeps with two red blinks
indicate timeout.
6. Replace the top inside cover.
Level 2 factory default reset
L Level 2 factory default reset will delete all congurations and settings in the lock
and the reader.
L Reader congurations that will reset to factory default include: keypad format,
magstripe reader track, beeper on/o󰀨, and contactless card.
L Days in use counter and lock type congurations will not reset.
To complete Level 2 factory default reset, repeat steps 2 through 5 above within 10
seconds of the conrmation signals of Level 1 factory default reset. If more than 10
seconds pass after the conrmation signals of Level 1 reset, then Level 1 reset will be
repeated.