Schlage AD-402 - Getting Started; Schlage Utility Software (SUS)

4 • Schlage • AD-400 user guide
Getting started
Follow these steps when setting up a new lock.
1. Install the lock. See the installation guide that came with the lock or visit
www.allegion.com/us for more information.
2. Make sure the batteries are installed properly. See Batteries on page 12 for more
information.
3. Congure the Master Construction Credential (where applicable). See Construction
access mode on page 6 for more information. The lock should remain in
Construction Access Mode until you are ready to set up the rest of the wireless access
system with connection to the PIM400 and the access control panel (ACP).
4. Link the lock to the PIM400. See Link to a PIM400 on page 8 for more information.
5. Test the lock for proper mechanical and electronic operation. See Test lock operation on
page 9 for more information.
6. Consult the SUS User Guide for information about conguring the lock and PIM400.
7. Familiarize yourself with the information contained in this user guide.
Save this user guide for future reference.
Schlage Utility Software (SUS)
The SUS is used to congure locks and the PIM400.
L When in a low battery condition the lock may operate but not have su󰀩cient
power to communicate with the SUS. When intitiating SUS communication,
the Schlage button will light solid red for one second to indicate power is not
su󰀩cient. If this should occur, change the batteries immediately. See Batteries on
page 12.
The SUS is used for programming lock characteristics and setup only. Access rights for the
AD-400/AD-402 are set by the access control panel, not by the SUS.
For more information about the SUS, see AD-Series Locks in the SUS User Guide.