4 Operation
SCHMIDT
®
PressControl 3000 – V1.3
17
Carry out a working stroke. After reaching the reference point, the press
moves automatically to the TDC position.
Servic......CtrOFFCtrON1
.000 mm
0 N
Reached stroke :
Reached force :
0 pcs
0 pcs
0 pcs
Quantity :
Quantity nok :
Quantity ok :
30.000 mmReturnstroke at stroke:
2-Hand-Release
Machine ok.
PC-DEAC
Dataset 1
( )
1
Figure 4-5: Display after the reference run
In general you can always carry out a reference run manually. During this
operation the control unit must not be switched off.
Change to operating level 3.
Select the “Ref” softkey.
Perform the reference run, as described above.
Manual reference run
To Next Page
Loading...