OPERATION
XH1500/XH1000 06-24 Operation Section 4-17
OPERATION
© 2024 Alamo Group Inc.
8. PRE-OPERATION INSPECTION AND SERVICE
Before each use, a pre-operation inspection and service of the implement and tractor must be performed. This
includes routine maintenance and scheduled lubrication, inspecting that all safety devices are equipped and
functional, and performing needed repairs. DO NOT operate the unit if the pre-operation inspection reveals
any condition affecting safe operation. Perform repairs and replacement of damaged and missing parts as
soon as noticed. By performing a thorough pre-operation inspection and service, valuable down time and
repair cost can be avoided. OPS-U-0029str
Always disconnect the main PTO Driveline from the Tractor before performing service on the
Implement. Never work on the Implement with the tractor PTO driveline connected and
running. Rotating Parts, Blades or Drivelines could turn without warning and cause immediate
entanglement, injury or death.
(S3PT-11)str
DO NOT allow any person under a folded wing unless the wing is securely
locked up or supported. DO NOT approach the Implement unless the
Tractor is turned off and all motion has ceased. Never work under the frame
work, or any lifted component unless the implement is securely supported
or blocked up. A sudden or inadvertent fall by any of these components
could cause serious injury or even death.
(STI-03) str
Periodically inspect all moving parts for wear and replace when necessary
with authorized service parts. Look for loose fasteners, worn or broken
parts, and leaky or loose fittings. Make sure all pins have cotter pins and
washers. Serious injury may occur from not maintaining this machine in
good working order. (SG-21 )str
To Next Page
Loading...