Schulte 5 Series - Driving the Tractor and Mower

OPERATION
XH1500/XH1000 06-24 Operation Section 4-29
OPERATION
© 2024 Alamo Group Inc.
When the Wings are folded for transport, the center of gravity is raised and the possibility of
overturn is increased. Drive slowly and use extreme caution when turning on hillsides.
Overturning the Implement could cause the Implement to overturn the Tractor and vice versa
resulting in serious injury or even death. Never fold wings on a hillside...the Implement or unit
may overturn.
(STI-02) str
Use extreme care when lowering or unfolding the implement’s wings. Make sure no
bystanders are close by or underneath the wings. Allow ample clearance around the
implement when folding or unfolding the wings. Use extreme caution around buildings or
overhead power lines.
(S3PT-05) str
9.4 Driving the Tractor and Mower
Start off driving at a slow speed and gradually increase your speed while maintaining complete control of the
tractor and mower. Moving slowly at first will also prevent the tractor from rearing up and loss of steering
control. The tractor should never be operated at speeds that cannot be safely handled or which will prevent
the operator from stopping quickly during an emergency. If the power steering or engine ceases operating,
stop the tractor immediately as the tractor will be difficult to control.
Drive the tractor with the 3-Point lift arms in the
raised position and lock the control lever in the
transport detent position to prevent damage to the
mower driveline and tongue when turning.
Perform turns with the tractor and mower at slow
speeds to determine how the tractor with an
attached mower handles a turn. Determine the
safe speed to maintain proper control of the
tractor when making turns. When turning with a
towed implement, the overall working length of
the unit is increased. Allow additional clearance
for the mower when turning, especially if the
wings are lowered.
To avoid overturns, drive the tractor with care and
at safe speeds, especially when operating over
rough ground, crossing ditches or slopes, and
turning corners. Tractor wheel tread spacing
should be increased when working on inclines or
rough ground to reduce the possibility of tipping.
Use extreme caution when operating on steep
slopes. Keep the tractor in a low gear when going
downhill. DO NOT coast or free-wheel downhill.
.