Basic safety notes
10 05.00 | AGE-XY | Assembly and operating manual | en | 389007
l
Do not recommission the product until the malfunction has
been rectified.
l
Test the product after a malfunction to establish whether it
still functions properly and no increased risks have arisen.
2.9 Disposal
Handling of disposal
The incorrect handling of disposal may impair the product's
safety and cause serious injuries as well as considerable material
and environmental harm.
l
Follow local regulations on dispatching product components
for recycling or proper disposal.
2.10 Fundamental dangers
General
l
Observe safety distances.
l
Never deactivate safety devices.
l
Before commissioning the product, take appropriate
protective measures to secure the danger zone.
l
Disconnect power sources before installation, modification,
maintenance, or calibration. Ensure that no residual energy
remains in the system.
l
If the energy supply is connected, do not move any parts by
hand.
l
Do not reach into the open mechanism or movement area of
the product during operation.
Possible electrostatic energy
Components or assembly groups may become electrostatically
charged. When the electrostatic charge is touched, the discharge
may trigger a shock reaction leading to injuries.
l
The operator must ensure that all components and assembly
groups are included in the local potential equalisation in
accordance with the applicable regulations.
l
While paying attention to the actual conditions of the working
environment, the potential equalisation must be implemented
by a specialist electrician according to the applicable regulations.
To Next Page
Loading...
Need help?
General
