Maintenance
05.00 | AGE-XY | Assembly and operating manual | en | 389007 19
6 Maintenance
6.1 Maintenance interval
CAUTION
Material damage due to hardening lubricants!
Lubricants harden more quickly at temperatures above 60°C,
leading to possible product damage.
l
Reduce the lubricant intervals accordingly.
Interval [Mio. cycles] 13
6.2 Lubricants/Lubrication points (basic lubrication)
During maintenance, treat all greased areas with lubricant.
Thinly apply lubricant with a lint-free cloth.
SCHUNK recommends the lubricants listed.
Lubricant point Lubricant
All seals Rivolta F.L.G. GT-2
Zentrierkolben Rivolta F.L.G. GT-2
The product contains food-compliant lubricants as standard.
The requirements of standard EN1672-2:2020 are not fully met.
NOTE
l
Change contaminated food-compliant lubricant.
l
Observe information in the safety data sheet from the
lubricant manufacturer.
CAUTION
Gleitfläche zwischen Speicherkolben (3) und Ausgleichskörper
(8) nicht einfetten! Der O-Ring (28) muss fettfrei sein!
(Position of the item numbers }7 [/21])
To Next Page
Loading...
Need help?
General
