Maintenance
20 05.00 | AGE-XY | Assembly and operating manual | en | 389007
6.3 Disassembling the AGE
Position of the item numbers }7 [/21]
1. Remove the pressure lines and disconnect the cable
connections.
2. Unscrew the screws (41) and remove the tool flange (7).
ð The tool flange (7) and compensation body (8) are aligned
to each other by means of pins (51).
3. Unscrew the screws (40) and remove the cover (6).
ð The cover (6) and housing (2) are aligned to each other by
means of pins (52).
4. Pull the accumulator piston (3) out of the housing (2).
5. Unscrew the screws (43) and remove the robot flange (1).
ð The robot flange (1) and housing (2) are aligned to each
other by means of pins (53).
6. Push the centering piston (4) with the cylinder piston (5) out
of the housing (2).
7. Unscrew the screws (44) and pull the centering pistons (4)
and cylinder pistons (5) apart.
6.4 Servicing and assembling the product
Maintenance
l
Clean all parts thoroughly and check for damage and wear.
l
Treat all greased areas with lubricant.
}6.2 [/19]
l
Oil or grease bare external steel parts.
l
Replace all wear parts / seals.
Assembly
Assembly takes place in the opposite order to disassembly.
Observe the following:
l
Unless otherwise specified, secure all screws and nuts with
Weicon no. 30243 and tighten with the appropriate tightening
torque.
To Next Page
Loading...
Need help?
General
