Assembly and settings
24
01.00 | ECG | Assembly and Operating Manual | en | 389769
5.2.4 ECG-W terminal configuration
5.2.4.1 Jumper operating voltage
NOTE
The operating voltage is preset and may only be changed by SCHUNK.
If the operating voltage is changed retroactively, contact SCHUNK.
5.2.4.2 External terminals power area
The voltage supply(1) and the power for the magnetic gripper(2)
are connected to the external terminals on the left side of the
magnetic gripper. The relay(3) is used to separate the magnetic
gripper completely from the product in order to protect it from
overvoltages, welding currents, etc.
Terminal Description
L1 Input voltage phase 1
L2 Input voltage phase 2
U1 Supply voltage magnetic gripper
V1 Supply voltage magnetic gripper
To Next Page
