Maintenance
38
05.00 | PGN-plus-P | Assembly- and Operating Manual | en | 0389753
7 Maintenance
7.1 Notes
Original spare parts
Use only original spare parts of SCHUNK when replacing spare and
wear parts.
Exchange of housing and base jaws
The base jaws and the guidance in the housing are matched. To ex-
change these parts, send the product with a repair order to
SCHUNK or order the housing with the base jaws as a set.
Seal replacement for variant with maintenance of gripping force
O.D. gripping
The pistons have to be aligned using an assembly device. There-
fore we recommend to replace the seals by SCHUNK.
The assembly device can be order at SCHUNK using on of the fol-
lowing numbers
gripper Ident number Assembly device
PGN-plus-P 40-AS -
PGN-plus-P 50-AS 1000302
PGN-plus-P 64-AS 1000303
PGN-plus-P 80-AS 1000304
PGN-plus-P 100-AS 1000305
PGN-plus-P 125-AS 1000306
PGN-plus-P 160-AS -
PGN-plus-P 200-AS -
PGN-plus-P 240-AS -
To Next Page
Loading...
