04.00|0889071 ROTA TP / ROTA TP-LH |en
Danger of limbs being crushed by opening and closing of the
chuck jaws during manual loading and unloading or when
replacing moving parts.
• Do not reach between the chuck jaws.
• Automatic loading is preferred.
• If manual loading is used, adjust the jaw position so that the
opening gap between the jaw and the workpiece is less than 4
mm.
• Wear protective gloves.
• Observe the safety and accident prevention regulations during
operation of the chuck, especially in connection with
machining centers and other technical equipment.
Risk of burns due to workpieces with high temperatures.
• Wear protective gloves when removing the workpieces.
• Automatic loading is preferred.
Risk of damages due to incorrect choice of clamping position for
chuck jaws on workpiece.
If an incorrect clamping position is chosen for the chuck jaws on
workpiece, the base and the top jaws may be damaged.
• The T-nuts combine the top jaws with the base jaws and they
should never protude over the base jaws in radial direction.
• The outer diameter of the screwed top jaws must not exceed
the outer diameter of the chuck by more than 10%.
To Next Page
Loading...
