SCHUNK ROTA TP Series - Clamping Force; Speed Diagrams

Technical data
18
04.00|0889071 ROTA TP / ROTA TP-LH |en
Technical data
Chuck data
Size
125-26
160-38
200-52
250-68
315-90
315-
105
315-
115
LH 350-
115
Chuck through bore
[mm]
26
38
52
68
90
105
115
115
Max. clamping force
[kN]
22
39
68
105
140
100
90
90
Max. rotation speed
[min-1]
4200
4200
3800
3500
2500
3000
2200
2200
Stroke per jaw [mm]
3.0
4.2
4.2
5.0
5.0
5.0
5.0
5.0
Serration of the jaws
[mm]
1/16"x90°
Chuck diameter
[mm]
130
165
205
255
320
335
350
350
Distributor ring Ø
[mm]
204
255
300
372
413
372
372
372
Centrifugal torque of
base jaw [kgm] M
cGB
0.012
0.033
0.061
0.118
0.186
0.200
0.209
0.275
Max. jaw eccentricity
of center of gravity in
axial direction [mm]
a
max
16
24
30
40
32
32
32
32
The specified maximum speed of rotation stated only applies when
using the maximum clamping force and the SHB-type, soft,
standard stepped jaws that go with the chuck.
WARNING
Risk of personal injury and property damage due to parts flying
off in the event of a screw breakage on unhardened top jaws!
• Soft standard top jaws must be hardened in the countersink
region.
They should only be depth-hardened, not surface-hardened.
Ensure minimal weight for all jaws.
For unhardened top jaws or chuck jaws in special design, the
permissible RPM according to VDI 3106 must be calculated for the
respective machining job. Whereby the recommended maximum
3
3.1