SCHUNK ROTA TP Series - Page 19

Technical data
04.00|0889071 ROTA TP / ROTA TP-LH |en
19
speed must not be exceeded. The values calculated must be
checked by means of dynamic measurement using a clamping
force tester.
Clamping force / speed diagrams
The diagrams refer to 3-jaw-chuck.
Clamping force/RPM curves have been calculated using hard jaws.
The chucks were operated with the max. permissable force and
the jaws were located exactly on line with the chuck O.D.
The chuck is in perfect condition and lubricated with SCHUNK
LINOMAX special grease.
Should one or several of the above mentioned parameters be
changed the diagrams are no longer valid.
Chuck set-up for clamping force / speed diagram
F/3
Clamping force per jaw
S
Center of gravity
r
s
Center of gravity radius
a
max
Max. jaw eccentricity of
center of gravity in axial
direction
F
max
Max. actuating force
3.2