consoles. The stationary mounting can be accomplished by using
M6 threaded holes on the rear face side of the distributor ring. It
must be ensured that the distributor ring is aligned with the chuck
body without contact. For this mounting type, the distributor ring
must be equipped with a spacer ring instead of the plastic
centering sleeve. This spacer ring is loosely enclosed with each
ROTA TP / TP-LH front-end power chuck. If the distributor ring is to
be fastened but is equipped standard with the centering sleeve,
the centering sleeve must be replaced with the enclosed spacer
ring.
Mounting with bracket
First, the lathe chuck is installed onto the machine spindle with the
loosely attached distributor ring and the distributor ring is aligned
flush with the stepped front side of the chuck. The height
dimension of the spacing consoles can only be determined by
measuring between the face side of the headstock and the rear
face side of the distributor ring. The determined dimension is the
height dimension of the spacing consoles. In this case, the distance
dimension a (see table above) is subtracted.
If the face side of the headstock is not machined, a mean must be
determined and any height differences must be compensated by
means of a positioning screw or positioning sleeve. Incidentally,
To Next Page
Loading...
