SCHUNK ROTA TP Series - Page 53

Commissioning and maintenance
04.00|0889071 ROTA TP / ROTA TP-LH |en
53
6 Lubricate valve system (item 18) and valve bore hole with oil,
install and close with plug-in screw and O-ring (item 3).
Note: All parts of the ROTA TP-type front-end power chuck are
lightweight. As such, hard hammer blows should never be
used during assembly.
7 Assembly of the distributor ring (see "Function" chapter
( 4, Page 29).
8 Screw the distributor ring cover (item 15) on the chuck body
with screws (item 35).