153
Short Instructions
SP 500 / 750-15 / 750-18 / 1000 / 1250 Operation Manual
Preparation
The Short Instruction section of this manual are for
quick reference only. Operator’s need to read through
and understand the entire manual.
Before using the Stationary Pump, please review the
following topics;
• Safety Manual - page 25
• Machine Overview - page 38
• Safety Equipment - page 34
• Personal Protection - page 63
• Unit Setup - page 67
• Machine Preparation - page 68
Safety Goggles
Breathing Mask
Safety Vest
Snug Fitting
Clothes
Gloves
Steel Toed Shoes
Hard Hat
Hearing Protection
Figure 1
Protective clothing
Starting the Machine
• Be sure all safety guards are in place.
• From the Rear Operator Panel, turn ignition switch
to the RUN position. The SCT controller will initial-
ize, the Schwing logo will appear on the screen.
When the system has nished initializing, the En-
gine Status screen will be displayed. When the
glow plug indicator icon disappears, turn and hold
the key switch in (III) START position; when the
engine starts - release. You can’t start the engine
until the SCT controller has initialized.
• After starting, the engine may be held at low speed
for a duration between 1 to 25 seconds to allow
engine systems to stabilize. The duration will de-
pend on the ambient temperature, time since last
run and other factors.
In ambient temperatures from 32 to
140°F (0 to 60°C), the warm-up time
is approximately 3 minutes. In tem-
peratures below 32°F (0°) additional
warm-up time may be required.
40
80
0
8
16
24
32
120
8060
ok
40
DEF
°C
PSI
LOW FUEL
RPM
+100
Start-Up Screen Engine Status Screen
Figure 2
Start up and Engine Status screen
• With the engine properly warmed-up, press the
Horn button, to clear the E-Stops.
• Use the Throttle Up button to increase engine
RPM’s. Press and hold this button until the engine
is at maximum RPM.
To Next Page
Loading...