50
Overview
SP 500 / 750-15 / 750-18 / 1000 / 1250 Operation Manual
Operator Panel Keypad
The Operator Panel Keypad contains 15 buttons used
to control various functions of the concrete pump. Each
button contains four indicator lights. These lights are
used to provide feedback on currently active functions.
Not every indicator light is used. Reference each button
for functionality. Buttons are as follows:
A. Local / Remote Control
B. Concrete Pump Forward
C. Stroke Limiter (+)
D. Vibrator Auto/Manual - On/O
E. Horn
F. Throttle (+)
G. Concrete Pump - O
H. Stroke Limiter (-)
I. Optional Accessories 3
J. Work Light - On/O
K. Throttle (-)
L. Concrete Pump - Reverse
M. Agitator - On/O
N. Optional Accessories 1
O. Optional Accessories 2
ACC3
ACC2ACC1
E
D
C
B
A
J
I
H
G
F
MN O
L
K
Keypad Buttons
Local/ Remote Button
Switches between the Local (Operator Panel) mode
and the Radio or Cable Remote mode . Upon start-up,
the button defaults to Local mode.
- Press once to change to Remote mode. Press
again to change back to Local mode.
= Local Mode
= Remote Mode
Concrete Pump - Forward
Puts the concrete pump into forward. This is called the
pumping position. Press once to put the concrete pump
in forward. If the concrete pump is in reverse, press and
hold to change from pump reverse to pump forward.
= Inactive
= Pump/Forward
Concrete Pump - O
Stops the concrete pump. Press once to shut the con-
crete pump o.
= Inactive
= Pump/Off
Concrete Pump - Reverse
Puts the concrete pump in the reverse. This is typically
used for cleaning out or unclogging jams in the pipeline.
Press once to put the concrete pump in reverse. If the
concrete pump is in forward, press and hold to change
from pump forward to pump reverse.
= Inactive
= Pump/Reverse
To Next Page
Loading...