Sea-doo 2004 3D RFI User Manual

CAUTION: Hangingtohandlebar
while falling might damage the
steering pole or other components.
The steering pole length multiply
the effect of your weight and this
creates an important stress on the
watercraft components.

WARNING
In the “vert” configuration, the
proper riding position is for the op-
erator to be on the rear platform
of the deck, behind the handle-
bar. Other riding positions may
not allow to remain in control
of the watercraft or may not offer
enough visibility of your surround-
ing, which could lead to accidents,
collisions and possible serious in-
juries.
”Moto” Configuration
It is recommended to deploy and stow
the “moto” seat when the watercraft
is out of the water or securely docked.
If not possible, it should be done on
calm water. Refer to the “MOTO”
SEAT RELEASE BUTTON for detailed
installation procedure.

WARNING
To avoid loss of control and colli-
sions before deploying or stowing
the “moto” seat:
-Stop the craft in a safe area, away
from traffic or obstacles.
-Turn off the engine.
-Be on the look out for other
crafts or obstacles. Your water-
craft could drift while changing
configuration.

WARNING
To avoid loss of control, always
make sure that seat is properly
locked in prior to operating the
watercraft.

WARNING
In the “moto” configuration, the
proper riding position is to sit
straddledonthe“moto” seat
withbothfeetrestingfirmlyon
the deck. Other riding positions
may not allow to remain in con-
trol of the craft or may not offer
enough visibility of your surround-
ing, which could lead to accidents,
collisions and possible serious in-
juries.
Kart Configuration
Refer to the KART SEAT LEVER sec-
tion for detailed installation procedure.

WARNING
-Only install or remove the kart
seat when the watercraft is out of
the water or docked securely on
calm water.
-To avoid loss of control, always
make sure that seat is properly
locked in and that the steering
pole is locked down, prior to oper-
ating the watercraft.

WARNING
-In the kart configuration, the
proper riding position is to sit on
the kart seat. It is not advisable to
ride in the “vert” position (i.e. in
a stand-up position) when the kart
seat is installed, but if this is un-
avoidable, proceed at low speed
with extra caution. Other riding
positions may not allow to re-
mainincontrolofthecraftormay
not offer enough visibility of your
surrounding, which could lead to
accidents, collisions and possible
serious injuries.
-Never sit on the kart seat backrest
for riding. This position does not
allow sufficient control of the craft
and could lead to serious injuries.
60
______________________
www.SeaDooManuals.net

Sea-doo 2004 3D RFI Specifications

General

Brand	Sea-doo
Model	2004 3D RFI
Category	Boat
Language	English