F22L06Z
Clean the water intake area. If the sys-
tem is still clogged, refer to an autho-
rized Sea-Doo dealer for servicing.
CAUTION: Inspect water intake
grate for damage. Refer to an au-
thorized Sea-Doo dealer for repair
as necessary.
Submerged Watercraft
To limit damage to the engine, per-
form the following procedure as soon
as possible.
Drain bilge.
If the watercraft was submerged in
salt water, rinse off the bilge and all
components with fresh water using a
garden hose to stop the corroding ef-
fect of salt.
CAUTION: Never try to crank or
start the engine of a watercraft
that has been submerged. Wa-
ter trapped in engine would cause
severe damage to the engine com-
ponents.
Bring the watercraft to be serviced by
an authorized Sea-Doo dealer as soon
as possible.
CAUTION: The longer the delay
before you have the engine ser-
viced, the greater will be the risk
and severity of the damage will be
to the engine.
Water-Flooded Engine
In the event the engine cannot be
serviced within a few hours, remove
spark plug cables and connect them
on the grounding device.
WARNING
Never crank engine with spark
plugs removed unless spark
plug cables are connected to
the grounding device. Be careful
when cranking engine, water will
spray out from spark plug holes.
Remove the spark plugs and wipe
them dry using a clean and dry cloth.
Cover spark plug holes with a rag.
To prevent fuel from being injected
into the engine, proceed as follows.
Remove safety lanyard from its post.
Depress and hold the throttle lever to
full throttle position. Wait 2 seconds
then, reinstall the safety lanyard cap
while keeping throttle lever fully de-
pressed.
Crank engine several times to allow
water to escape from spark plug open-
ings.
Release throttle lever.
Spray BOMBARDIER LUBE or an
equivalent lubricant into spark plug
holes.
Crank engine again.
Start engine normally.
Fuel-Flooded Engine
To prevent fuel to be injected in the
engine, proceed as follows.
_____________________
67
To Next Page
Loading...
Need help?
General