EasyManuals Logo

Sea-doo 2004 3D RFI User Manual

Sea-doo 2004 3D RFI
118 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #68 background imageLoading...
Page #68 background image
Remove safety lanyard from its post.
Depress and hold the throttle lever to
full throttle position. Wait 2 seconds
then, reinstall the safety lanyard cap
while keeping throttle lever fully de-
pressed.
Crank engine approximately 5 sec-
onds.
Release throttle lever and crank again
to start engine.
If this does not work:
Remove spark plug cables and con-
nect them on the grounding device.
WARNING
Always use spark plug cable
grounding device whenever re-
moving spark plugs. Never crank
engine with spark plugs removed
unless spark plug cables are con-
nected to the grounding device.
Remove spark plugs and wipe them
dry using a rag.
Cover spark plug holes with a rag.
Crank engine several times.
Reinstall spark plugs. Install clean dry
spark plugs if possible. Reconnect ca-
bles.
Start engine as explained above. If en-
gine remains flooded, see an autho-
rized Sea-Doo dealer.
Towing the Watercraft
on the Water
Special precautions should be taken
when towing a Sea-Doo watercraft on
the water.
The maximum recommended towing
speed is 24 km/h (15 MPH).
When towing your watercraft on
the water, pinch the water supply
hose from the impeller housing to
the engine with a large hose pincher
(P/N 529 032 500).
F01B23Y
This will prevent the cooling system
fromfillingupwhichmayleadtowater
flooding the exhaust system pushing
water back into the cylinders. When
the engine is not running there isnt
any exhaust pressure to push the wa-
ter out the exhaust outlet.
CAUTION: Failuretodothismay
result in damage to the engine. If
you must tow a stranded watercraft
on the water and do not have a hose
pincher, be sure to stay well below
the maximum towing speed of 24
km/h (15 MPH).
Clamp down the hose pincher on the
water supply hose as shown.
NOTE: A red tape on the water supply
hose indicates which hose to pinch.
F22E01Y
1
2
3
1. Water supply hose
2. Install hose pincher here on this
side of the T-fitting
3. T-fitting
68
______________________
www.SeaDooManuals.net

Table of Contents

Other manuals for Sea-doo 2004 3D RFI

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sea-doo 2004 3D RFI and is the answer not in the manual?

Sea-doo 2004 3D RFI Specifications

General IconGeneral
BrandSea-doo
Model2004 3D RFI
CategoryBoat
LanguageEnglish

Related product manuals