F22L0SY
Firmly push the post in the seat until
you hear a “clunk“.
CAUTION: Make sure to maintain
the seat high enough so that the
post clears the body when rotated
forward into the seat. Make sure
that the post is latched properly.
Keep steering pole high enough and
rotate seat in steering pole. Firmly
push seat in steering pole until you
hear a “clunk“.
F22L0LZ
CAUTION: Make sure to maintain
the steering pole high enough so
that the “moto” seat clears the en-
gine cover when rotated forward
into the pole.
26) “Moto” Seat Post
Receiver
The receiver locks the seat post into
position on the deck. For instructions,
refer to “MOTO” SEAT INSTALLA-
TION/STOWAGE above.
F22L0UY
1
1. Receiver
27) “Moto” Seat Post
Release Lever
The lever releases the seat post from
within the seat. It is used also to
release the post from its receiver
on the deck. For instructions, re-
fer to “MOTO” SEAT INSTALLA-
TION/STOWAGE above.
28) Kart Seat Lever (if
so equipped)
The lever releases the latch locking the
seat on the deck.
WARNING
Only remove or install the kart seat
when the watercraft is out of the
waterordockedsecurelyoncalm
water.
_____________________
43
To Next Page
Loading...
Need help?
General