MAINTENANCE
WARNING
Only perform procedures as de-
tailed in this guide. It is recom-
mended that the assistance of an
authorized Sea-Doo dealer be peri-
odically obtained on other compo-
nents/systems not covered in this
guide. Unless otherwise speci-
fied, engine must not be running
and the safety lanyard must be re-
moved from its post for all main-
tenance procedures. Components
inside engine compartment may
be hot. Never use jet pump com-
ponents or steering pole to lift the
watercraft.
Lubrication
Seal Carrier
Use Sea-Doo synthetic grease or
equivalent.
Remove rear access cover to gain ac-
cess to seal carrier.
F22L0JY
1
1. Rear access cover
Using a grease gun, carefully lubricate
seal carrier of mid bearing until grease
is just coming out of the seal.
F22J05Y
1
1. Grease seal carrier of mid bearing
Reinstall properly all removed parts.
Anticorrosion Protection
Throttle Cable
Lubricate the throttle cable with BOM-
BARDIER LUBE or an equivalent lubri-
cant.
Electrical Connections
As necessary, apply anticorrosion
product such as dielectric grease on
battery posts and all exposed cable
connectors.
CAUTION: Never lubricate connec-
tors of the MPEM (Multi-Purpose
Electronic Module).
Additional Lubrication
BOMBARDIER LUBE or an equivalent
lubricant will help prevent corrosion
of metallic parts and maintain proper
operation of mechanisms and mov
ing
parts.
WARNING
Never lubricate the safety lanyard
post.
Throttle Body and Oil Injection
Pump
Lubricate springs, shafts and exposed
portion of cables.
_____________________
77
To Next Page
Loading...
Need help?
General