When safety lanyard cap is installed on
its post, the bilge pump is automati-
cally turned on. It will remain on until
all water is evacuated,then it will shut
down automatically.
When engine is running, the bilge
pump will automatically start periodi-
cally to evacuate water.
25) “Moto” Seat Release
Button
Thisbuttonisusedtounlatchthe
“moto“ seat stowed into the steering
pole.
CAUTION: Prior to using this but-
ton, ensure that the steering pole is
raised to its highest position and is
held there firmly.
NOTE: It is suggested to deploy or
stow the “moto“ seat when the wa-
tercraft is out of the water or when se-
curely docked. If this is not possible,
it should be done on calm water.
“Moto” Seat Installation
WARNING
Before installing or stowing the
“moto” seat.
- Stop the watercraft in a safe area
away from traffic or obstacles.
- Turn off engine.
- Be on the look out for other
crafts or obstacles. Your water-
craft could drift while changing
configuration.
Raise the steering pole to its highest
position and firmly hold there.
With the other hand, pull the release
button.
F22L0KY
1
1. Release button
Pull the “moto“ seat out of the steer-
ing pole.
CAUTION: Pay attention so that the
“moto“ seat does not rub against
the engine cover.
Rotate the seat out, raise and pull rear-
wards. Hold in this position.
F22L0LY
Keep the seat high enough to pull the
seat post out.
40
______________________
To Next Page
Loading...
Need help?
General