NOTE: It may be necessary to posi-
tion the end of the hose in a lower area
of the bilge to allow proper drainage.
1
2
F17E0BY
TYPICAL
1. Fitting
2. Hose
Reconnect hose when done.
Body Rinsing/Repair
Wash the body with soap and water
solution (only use mild detergent).
Rinse thoroughly with fresh water.
Remove marine organisms from the
hull.
CAUTION: Never clean fiberglass
andplasticpartswithstrongdeter-
gent, degreasing agent, paint thin-
ner, acetone, etc.
For small gelcoat repairs, refer to an
authorized Sea-Doo dealer. Replace
damaged labels/decals.
Propulsion System
Lubricant in jet pump reservoir should
be drained and reservoir cleaned. Re-
fer to an authorized Sea-Doo dealer for
this operation.
Grease lubrication point(s) of propul-
sion system as explained in MAINTE-
NANCE section.
Fuel System
Sea-Doo fuel stabilizer (or equivalent),
can be added in fuel tank to prevent
fuel deterioration and gumming. Fol-
low manufacturer’s instructions for
proper use.
CAUTION: Fuel stabilizer should
be added prior to engine lubrication
to ensure fuel system components
protection against varnish deposits.
WARNING
Alwaysstoptheenginebeforere-
fueling. Fuel is flammable and ex-
plosive under certain conditions.
Always work in a well ventilated
area. Do not smoke or allow open
flames or sparks in the vicinity.
Fuel tank may be pressurized, turn
cap slowly when opening. Never
use an open flame to check fuel
level. When fueling, keep water-
craft level. Do not overfill or top
off the fuel tank and leave water-
craft in the sun. As temperature
increases, fuel expands and might
overflow. Always wipe off any
fuel spillage from the watercraft.
Periodically verify fuel system.
Cooling System Flushing and
Engine Internal Lubrication
Refer to procedure in POST-OPERA-
TION CARE.
Battery
Contact your authorized Sea-Doo
dealer.
Antifreezing Protection
In cool regions where freezing point
may be encountered, cooling system
should be filled with pure antifreeze.
86
______________________
To Next Page
Loading...
Need help?
General