F22L10Y
1
1. Pull post retainer out
Continue lowering the steering pole
down until the retainer can be insert-
ed into the body hook. Then, push re-
tainer to lock in position.
F22L11Y
1
2
1. Position retainer in body hook
2. Push to lock
Models not Equipped with a
Post Retainer
Use a bungee cord, wrapped with
rags, where shown.
F22L15Y
1
1. Tiedownsteeringpolehere
CAUTION:
Trailering the watercraft
without properly tying down steer-
ing pole might result in damage to
the watercraft.
All Models
Always observe all trailering safety
precautions.
Launching/Loading
CAUTION:
Before launching the
watercraft, make sure the bilge
plugs are installed and screwed in
tight. After loading the watercraft,
make sure to remove them to drain
bilge.
Storage
WARNING
Since fuel and oil are flammable,
have an authorized Sea-Doo deal-
er inspect the fuel and oil systems
integrity as specified in the period-
ic inspection chart.
It is strongly recommended that the
watercraft be serviced by an autho-
rized Sea-Doo dealer for storage but
the following operations can be per-
formed by you with a minimum of
tools.
CAUTION:
Do not run the engine
during the storage period.
Engine Draining
Check engine drain hose (lowest hose
of engine). Make sure it is free of sand
or other particles and unobstructed so
that water can drain out of the engine.
Clean hose and fitting as necessary.
CAUTION:
Water in engine drain
hose should be free to flow out,
otherwise water could be trapped
in engine. Should water freeze in
engine, severe damage would oc-
cur. Check engine drain hose for
obstructions.
_____________________
85
To Next Page
Loading...
Need help?
General