EasyManuals Logo

Sea-doo 2005 3D RFI User Manual

Sea-doo 2005 3D RFI
123 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #61 background imageLoading...
Page #61 background image
NOTE: If you hear anything other
than 2 short beeps from DESS sys-
tem, it indicates a particular condition
that should be corrected. Refer to the
TROUBLESHOOTING section for the
meaning of the coded signal.
WARNING
Before starting the engine, the op-
erator should always be properly
seated or have a stable stance in
the vert configuration.
Firmly grip the handlebar with your
hands and properly place both feet on
the floorboard. In the vert configu-
ration, keep both feet spread apart to
achieve a stable stance.
CAUTION:
Ensure there is at least
90 cm (3 ft) of water underneath the
lowest rear portion of the hull when
you are onboard prior to starting the
engine. Otherwise damage to the
impeller or other jet pump compo-
nents might occur. Do not acceler-
ate abruptly.
To start engine, depress and hold the
engine start/stop button. Follow the
procedure below for cold or warm en-
gine starting.
If engine fails to start after 10 seconds,
wait a few seconds then repeat proce-
dure.
CAUTION:
Do not hold the
start/stop button more than 30 sec-
onds to avoid starter overheating.
A rest period should be observed
between the cranking cycles to let
the starter cool down. Be careful
not to discharge battery.
Release the engine start/stop button
immediately once the engine is start-
ed.
Cold or Warm Engine
Never depress the throttle lever to
start engine wether it is warm or cold.
Riding
Evenly accelerate to reach deeper wa-
ter. Do not apply full throttle until the
engine is warm.
WARNING
Never attempt to perform jumps
or stunts as they could lead to
serious injuries or death.
To make sure your riding po-
sition allows you to remain in
control and locate any upcom-
ing craft or obstacle, only adopt
riding positions that are recom-
mended by the manufacturer.
CAUTION:
Avoid operating the
watercraft in weeded areas. If un-
avoidable, continuously vary the
watercraft speed.
”Vert” Configuration
F22L1UY
When operating the watercraft in the
vert position, always keep both feet
on the platform. Raising a foot in-
creases the possibility of loosing your
balance and fall.
WARNING
In the event of a fall, do not hold on
to the handlebar. Attempting to do
so could result in an injury.
60
______________________
www.SeaDooManuals.net

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sea-doo 2005 3D RFI and is the answer not in the manual?

Sea-doo 2005 3D RFI Specifications

General IconGeneral
BrandSea-doo
Model2005 3D RFI
CategoryBoat
LanguageEnglish

Related product manuals