SEA USER 1 - Special Menu Functions (Cont.); Special Menu Functions Table - Part 2

SELECTION OF THE SETTINGS
UPDOWN
USER 1 - 24V DG
MENU SP
SET
Default
open
open
stop
rp.pa
Los
Par
U
L.i
Pk.2
alys
alys
open
pk.te
24ua
N
Pa s
Op. L
Los
pk.e
6
0 100
re.ps
0 100
D sb
U
R. Ot
D sb
O.ope
all.r
D sb
D sb
Op. L
O. Lo
off
on
L.ti
U
off
0 10
D ag
ph.te ph.i2
ph.i
ph.2
ph.1.2
T.opn
T.clo
0 100%
0 100%
0
0
PRESS AT THE SAME TIME FOR 5 SECONDS TO ENTER OR TO EXIT THE SPECIAL MENU
SPECIAL MENU FUNCTIONS TABLE USER 1 24V DG
(To enter the Special Menu keep pressed UP and DOWN at the same time for 5 seconds.
To exit the Special Menu pressed END or keep pressed UP and DOWN at the same time for 5 seconds)
Description
Description
Set value
Photocell 2 management
Photocell active in closing
Photocell active in opening
and closing
Photocell active even
before opening
Photocell stops in closing and
closes when released
The photocell gives a command to
close during opening, pause
and closing
Photocell charging the pausing time
24Vaux output management
24Vaux output always power supplied
24Vaux output power supplied only
during opening and closing
24Vaux output power supplied
only during opening
24Vaux output power supplied
only during cloisng
24Vaux output power supplied
only during pause
24Vaux output for connection of
photocell TX to autotest
Phototest economy
Output for Self-test ON only
during the operation of the motors.
Position recovery
Regulates the recovery of the
motor inertia
Limit switch inversion
Disabled
Adjusts the space of return after
reading of the limit switch
Anti-Intrusion alarm
Disabled
Only on limit switch in closing
On limit switches in closing
and in opening
Only on limit switch in opening
Allows to keep the light switched off
when the timer is active
Allows to keep the courtesy light
switched on when the timer is active
Courtesy light with timer
management
Adjusts the amperometric tolerance
in relation to the detected stop
in closing
Adjust the amperometric tolerance
in relation to the detected stop
in opening
Amperometric tolerance
management in opening
Amperometric tolerance
management in closing
Events diagnostic
Shows last event
(See alarms table)
Auto-test photocells
Auto-test active on Photo1 and Photo2
Auto-test active only on Photo1
Auto-test active only on Photo2
13
International registered trademark n. 2.777.971
67411535 REV 03 - 05/2013