1
F18L090
1. Press TOGETHER and hold for 2 seconds
Trip Hour Meter
While in the trip hour meter mode:
1
F18L092
1. Press to start or stop trip hour meter
1
F18L092
1. Press and hold for 2 seconds to reset
Trip hour meter is reset every time en-
gine is turned off.
Message Display
The information center features a
display area that blinks a message
whenever one of the following cir-
cumstances occurs. The abbrevia-
tions between parenthesis here are
the code displayed:
– engine or exhaust system overheat-
ing (H-TEMP)
– low oil pressure (OIL)
– low battery voltage (12V LOW)
– high battery voltage (12V HI)
– low fuel level (FUEL-LO)
– maintenance reminder (MAINT)
– check engine (CHK ENG)
– sensor failure (vehicle electronic
equipment) (SENSOR)
– invalid safety lanyard (KEY)
– safety lanyard, learning key active
(L KEY)
– end of faults (END).
A beeper will sound depending on the
fault occurring to catch the driver at-
tention when necessary.
Except for low liquid levels, which can
be corrected by refilling, it is recom-
mended to see an authorized Sea-Doo
dealer when other messages occur.
NOTE: If a fault occurs, this sys-
tem generates numbered fault codes
(P-XXXX) that can be displayed
through the information center us-
ing a special procedure. In case of a
failure, you may call your authorized
Sea-Doo dealer and he would be able
to assist you to have the codes dis-
played to help troubleshooting.
Warning Light
The red warning LED (Light-Emitting
Diode) blinks along with the beeper to
catch your attention.
40
______________________
Print Preview Version 8.0 PubTeX output 2003.11.07:1153 File: C:\TEMP\.aptcache\smo2004-003en/tfa00394.dvi User: CASS2 Page: 42
To Next Page
Loading...