Seaga Quick Break Combo QB2000 - Page 64

64QB2000 9.2022 vers 1.0
2. Make sure all product loaded is installed in the correct selecon. Load product according to the
machine Plan-O-Gram. A change from the Plan-O-Gram may require new setup. See the Loading
Beverage Lanes secon of this manual and study the Product Groups and how to load them and
accessories required (if any).
3. Make sure the Sensivity Adjust (Menu > 5 Opons > 9 Sensivity Adjust, see Programming secon
of this manual) is set properly. If the sensivity is set too high, the sensor may trip before the product
drops and stop the vend process prematurely. Under advisement from technical support,
change the sensivity from high to medium or medium to low and test vend.
My beverages are vending more than one at a me.
1. Make sure all items are loaded correctly. Review Loading Beverage Lanes secon of this manual and
verify all recommendaons and steps are followed for your type of packaging.
2. Make sure the Drop Sensor Sensivity (Menu > 5 Opons > 9 Drop Sensor, see Programming secon
of this manual) is set properly. If the sensivity is set too low, the sensor may not trip when the
product drops and perform a second vend. Under advisement from technical support, change
the sensivity from medium to high or low to medium and test vend.
The selecon vends ne in Test Mode, but during Sales Mode says Make Alternate Selecon.
1. You have an error code or a jam blocking the use of that parcular selecon. You will need to empty
all products and make sure there are no jams. Return the auger to the home posion and reload the
product. Then go to the menu and press 7 to recapture motors. This will allow you to resume vending
from that parcular selecon(s).
Power
I can see and hear the cooling deck fans, but there is no power to the rest of the machine. What does this
mean?
1. Check the transformer on the oor of the machine. There is a cover that goes over the transformer
with access to the small breaker switch on top of the transformer. Press the breaker switch to reset the
transformer. This should cause the machine to power back up.
2. Check to make sure that the main power harness that runs from the transformer to the VMC. Make
sure all connecons are good.