Seaga Quick Break Combo QB2000 - Safety and Handling Precautions

6QB2000 9.2022 vers 1.0
Power Requirements
The wall receptacle used for your vendor must be properly polarized, grounded and of the correct voltage.
Operang the QB2000 system from a source of low voltage will VOID YOUR WARRANTY. Each QB2000 system
should have its own 15 Amp electrical circuit that is protected by a circuit breaker or fuse conforming to local
power safety regulaons.
Unpacking the Vending System
Remove all packing materials from the interior of the vending machine. Keep all documents found packed
inside which include payment system and accessory manuals as appropriate. Keep and set aside any accessory
kits.
Controls and Indicators
The Display is how the vending system communicates with your customers while they are in front of the ma-
chine. The customer may see messages about how much an item costs, when a selecon is sold out, and other
communicaon. The Display also shows you, the operator, the programming mode and can show you errors or
other important diagnosc informaon.
Keypad
The customer uses these buons to make selecons. The operator uses these buons to program and/or test
the system.
Coin Return Buon
Pressing this buon returns any credit that has been paid in to the vending machine prior to a vend unless
Forced Vend is turned on.
Bill Acceptor
Accepts bills in various denominaons depending upon the conguraon of the bill validator unit.
VMC
The VMC is the Vending Machine Controller and is the heart of the vending system. The VMC is where the
Menus buon is located to put the system into programming mode.
CAUTIONS
Your vender is intended for indoor use only.
Excessive heat, cold or humidity levels will void your warranty; install only in climate
controlled, indoor environments. For indoor machines the temperature range must be no
higher than 32°C/90°F and no lower than 10°C/50°F with a relave humidity (Rh) level of no
greater than 40%.
Your vender must be set on a level, well-supported locaon.
Always remove products before transporng it.
CAUTION!
It is important that this machine is hooked up to the proper voltage. Verify the voltage before
connecng the machine to a wall outlet.