Seaga Quick Break Combo QB2000 - Initial Setup and Installation

8QB2000 9.2022 vers 1.0
Inial Setup
Moving the Vending System
Your QB2000 system should never be moved with product or coins loaded, it should be completely empty, and
any moving parts must be secured.
The system can be located as close as 2 inches to the back wall but requires 6 inches clearance on either side
for the doors to open properly while you service the machine.
Aer locang your vending system, plug in the power cord and the system will turn on.
Front Door
Unlocking – Insert the key into the lock and turn the key clockwise unl the T-Handle pops out – then turn the
T-Handle counter-clockwise 3 or more revoluons unl the door can be pulled open.
Locking – Close the door rmly. Turn the lock housing one revoluon clockwise and pull to test that the lock
spear has engaged with the locking mechanism. If the door does not open, push the lock housing into its
seated posion in the door.
Locaon Requirements
The QB2000 is meant for operaon indoors only – which not only means physical protecon from the elements
of sun, rain, etc. but also means a climate-controlled environment. Locang the QB218 in excessively hot, cold,
humid or dirty locaons will VOID YOUR WARRANTY.