Name: SeaLand Mass Flow Meter
Brand: SeaLand
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Zhejiang Sealand Technology Co.,Ltd.

5. Comes interface ; sweep over screen until comes interface

; press SELECT until turns up; press SET until indicator light turns

red & blinks; comes pop-up menu, asking whether to clear; sweep over SET for yes,

SELECT for no; sweep SET/SELECT to confirm; done;

6. Press SELECT until comes pop-up menu, asking whether to return to main interface;

sweep over SET for yes, SELECT for no, and sweep over SET/SELECT again to confirm.

● By software

Start the software; check tool bar on the top; click Functions --> Totalizer Control; comes

setting interface; click Reset Mass Total; done.

7.8 Volume calculation setting

Mass flow meter measures mass directly; however, some customer wants to show in volume

unit, such as L, gallon. In this way, transmitter has to process mass into volume. This

function is meaningless if you apply mass directly.

● By transmitter

1. On main interface, sweep over screen as Pic. 7-1 until comes interface ;

2. Sweep over SET/SELECT as Pic. 7-2 until cursor points to ;

3. Press SET until indicator light turns red & blinks, comes the password input interface;

4. Input password:

a. Sweep over SET/SELECT to set the value, SET=Decrease, SELECT=Increase.

b. Sweep over screen to move to nearby digit, from SET to SELECT=Move right,

SELECT to SET=Move left.

c. Press SET until indicator light turns red & blinks, to confirm password( or press

SELECT until indicator light turns red & blinks, to cancel operation).

5. Comes interface ; sweep over screen until comes

interface ; sweep over SET/SELECT until cursor points to FixedDensity

or RealTimeDensity; press SET until indicator light turns red & blinks; done. Fixed density

has to be inputted if select FixedDensity( refer to Step 4).

5.Press SELECT until comes pop-up menu, asking whether to return to main interface;

sweep over SET for yes, SELECT for no, and sweep over SET/SELECT again to confirm.

● By software

Start the software; check tool bar on the top; click Functions --> Volume Measurement

Config; comes setting interface; click Standard Density or Real Density; click Apply; done.

SeaLand Mass Flow Meter User Manual

Questions and Answers: