SeaLand Mass Flow Meter - Chapter 11 Transport and Storage

Zhejiang Sealand Technology Co.,Ltd.
7
Wiring requirements
a) Cut off power before wiring;
b) Use correct wire;
c) Correct steps to thread wire: Loosen locknut; remove block board; thread wire through
locknut, rubber ring and wire plug all at once; do the wiring; settle wires; tighten locknut.
d) Do not damage insulating layer when pare wire. For sensor signal input wire, do not pare
shielding layer if wirable.
4.2 Wiring between sensor & transmitter
Sensor and transmitter are connected through a 12-pin cable, provided by manufacturer.
The definition is as follows.
Table 4-1 Terminal definition
Chapter 5 Operation interface
5.1 Operation panel
Pic. 5-1 Transmitter schematic
There are 2 infrared sensors, SET and SELECT, between which there is a indicator light,
which blinks green once per second during operation, and blinks red when infrared sensor
detects operation.
S/N
1
2
3
4
5
6
7
8
9
10
11
12
Code
R+
R-
PE
L+
L-
TPE
S
2
S
1
C
1
DPE
D-
D+
Color
white
yellow
black
(shield)
gray
purple
black
(shield)
black
green
orange
black
(shield)
red
blue
Function
Right, left coil detection
Temperature detection
Coil driver