Zhejiang Sealand Technology Co.,Ltd.
Standard density has to be input if select Standard Density. Status below will show the
current volume calculation method you select.
7.9 Measurement unit setting
1. On main interface, sweep over screen as Pic. 7-1 until comes interface ;
2. Sweep over SET/SELECT as Pic. 7-2 until cursor points to ;
3. Press SET until indicator light turns red & blinks, comes the password input interface;
4. Input password:
a. Sweep over SET/SELECT to set the value, SET=Decrease, SELECT=Increase.
b. Sweep over screen to move to nearby digit, from SET to SELECT=Move
right, SELECT to SET=Move left.
c. Press SET until indicator light turns red & blinks, to confirm password( or press
SELECT until indicator light turns red & blinks, to cancel operation).
5
. Comes interface ; sweep over screen until comes interface
; sweep over SET/SELECT until cursor points to the unit you need
to change; press SET until indicator lights turn red & blinks, the unit will change at the
same time, operate again until it changes to the unit you need; done.
6.Press SELECT until comes pop-up menu, asking whether to return to main interface;
sweep over SET for yes, SELECT for no, and sweep over SET/SELECT again to confirm.
KG(kilogram) LB(pound) T(ton)
L(liter) us_gal(US gallons) uk_gal(Imperial gallons)
°C(Celsius) °F(Fahrenheit) K(Kelvin)
Table 7-1 Unit table
7.10 Password setting
1. On main interface, sweep over screen as Pic. 7-1 until comes interface ;
2. Sweep over SET/SELECT as Pic. 7-2 until cursor points to ;
3. Press SET until indicator light turns red & blinks, comes the password setting interface;
4. Input old password
a. Sweep over SET/SELECT to set the value, SET=Decrease, SELECT=Increase.
b. Sweep over screen to move to nearby digit, from SET to SELECT=Move right,
To Next Page
Loading...
Need help?
General