6.7.2.6 Manually joining/leaving the network
The Network button
from the advance Settings menu allows
Pipit to be manually joined to or removed from the HAN. The
automatic HAN joining process supersedes any manual HAN
connection and will start only after the unit is manually removed
from a HAN. Pressing the button causes a prompt for the PIN code
to be displayed. If the correct PIN is entered the following warning
message will appear before the manual process starts.
Press OK to join or leave the network, or press Cancel to return to the advance Settings menu without
affecting the network connection.
6.7.2.7 PIN code entry
Making any changes to advanced settings will require a PIN code to be entered, as shown here:
The above PIN code entry screen appears whenever an attempt is made to change any of the advanced
settings. The PIN is a four-digit number, as shown in the above screen. Enter the PIN ‘1793’ using the keypad
on the screen and then press OK. Entering the correct PIN will enable the requested change to be made. An
incorrectly entered PIN will cause the following warning message to be displayed:
Wrong PIN warning:
PIN code
Press OK to re-enter
the PIN code.
To Next Page
Loading...
Need help?
General