7
Use the and buttons to increase
or decrease the maximum temperature
setting.
Note: To activate this change in the
maximum temperature setting you must
press SELECT, and the new temperature will
be saved in memory.
To return to Operational Mode either wait for
the 15 second timeout or press MODE
Note: Reset default for maximum
temperature is 30
0
C
System Minimum Temperature
The controller uses the minimum
temperature to control the point at which the
fan speed drops to speed 1 if no heater is
fitted or drops to speed 2 if a heater is fitted
and enabled, or drops to speed 1 if a heater
is fitted and disabled. This temperature is
adjustable from 0
0
C to at least 5
0
C below the
maximum temperature.
Note: The controller will not allow the
minimum temperature to be set greater than
the maximum.
To change or check the value of the
minimum temperature enter the Setup Mode
as follows:
(Press x3)
Use the and buttons to increase
or decrease the minimum temperature
setting.
Note: To activate this change in the
minimum temperature setting you must
press SELECT, and the new temperature will
be saved in memory.
To return to Operational Mode either wait for
the 15 second timeout or press MODE
Note: Reset default for minimum
temperature is 5
0
C
System
Max. Temp
Max. Temp
= 31
.
C
MODE
SELECT
SELECT
SELECT
MODE
SELECT
MODE
System
Min. Temp
Min. Temp
= 5
.
C
To Next Page
Loading...