To Next Page

To Previous Page

The protection device performs a validity

check, and after this, it uses the new setting

(unless it detects a validity problem).

If the validity check should fail, i. e. the protection device detects some validity problem

or incosistency with respect to the new value(s) then this is indicated by a big “?”

character that appears instead of the “*” in the heading line. In this case the protection

device refuses to activate the new value(s), and you are expected to re-edit the values

that are marked by the “?”.

112 WIC1 WIC1-1.0-EN-MAN

3 Hardware

3.9.1.4 Parameter Changes – “OK” key

Questions and Answers:

Need help?

Do you have a question about the Seg WIC1-3 and is the answer not in the manual?

Seg WIC1-3 Specifications

General