ASSEMBLY AND INSTALLATION
23
6
1
Move the product to the installation site. If the product is to be installed near a wall, secure enough
passageway space for players to access the seat. You must also secure a 15cm space between the back wall
and the back of the cabinet for ventilation
2
Bring the adjusters into direct contact with the oor. Use a wrench to align the height of the adjusters until
the Cabinet is perfectly level
3
After setting, turn adjuster nuts upwards to tighten them and secure adjuster heights
Make sure that all the adjusters contact the oor. Otherwise the Cabinet could
move, causing an accident
The product comes with castors attached at 2 locations and adjusters at 2 locations.
When the installation site has been determined, have the adjusters come in direct contact with the oor. Establish a
gap of about 5 mm between the oor and the castors and adjust the unit so that it will remain level.
6-4 FIXATION TO INSTALLATION SITE
CASTOR (2)
ADJUSTER (2)
To Next Page
Loading...
Need help?
General
