Sega bop it ARCADE - 6. INPUT TEST; 7. OUTPUT TEST

EXPLANATION OF TEST AND DATA DISPLAY
47
9
• Pressing TEST will cycle through the LED Matrix animations & messages.
6. INPUT TEST
o Switch Inputs
• The current status of all on-board DIL inputs is shown on the display.
• “0” indicates a switch is OFF.
• “1” indicates a switch is ON
 The current status of the TEST & SERVICE inputs is show on row 2 of the LCD display.
• An audio sample will be played whenever an input state changes.
 To exit from Switch Test, press the TEST and SERVICE buttons simultaneously.
o Controllers TEST
• The current status of the BOP IT control is shown.
• An audio sample will be played whenever an input state changes.
• Press the SERVICE button to exit from this test.
• The current status of the TWIST IT control is shown.
• An audio sample will be played whenever an input state changes.
• Press the SERVICE button to exit from this test.
***This is repeated for the remaining controllers - , Pull It, Twist It & Spin It.
o Opto Input Test
• The state of the Ticket Opto signal is displayed. The state of the input is changed as
a ticket passes through the opto.
7. OUTPUT TEST
DIL SW1-6 000000
TST–OFF SRV-OFF
INPUT TEST
OPTO INPUTS
CONTROLLERS
BOP IT: OFF
CONTROLLERS
FLICK IT: OFF
MATRIX
SHOW IMP = 01