Need help?Do you have a question about the SELTEX V350 and is the answer not in the manual?
General| Brand | SELTEX |
|---|---|
| Model | V350 |
| Category | Gate Opener |
| Language | English |
Specifies opening angle based on distance D, and provides tables for bracket hole selection.
Instructions for horizontal placement of the pillar side bracket using a spirit level.
Instructions for horizontal placement of the gate side bracket and securing the actuator.
Guidance on connecting motor wires to a 12VDC battery to test actuator movement direction.
Instructions for opening, accessing, and fixing the control box on a wall, with screw recommendations.
Procedure for mounting wire conduit, feeding the AC cable, and checking the LED indicator.
Guidance on connecting the transformer, replacing the control box cover, and fastening screws.
Details on connecting the motor wires to the PCBA terminals for gate operation.
Instructions for wiring photocells to the PCBA, including jumper settings.
Guide on connecting the warning light wires to the designated terminals on the PCBA.
Specific instructions for connecting actuator motor wires to PCBA for inward/outward opening.
Step-by-step guide for opening, connecting wires, and mounting the warning light on the pillar.
Instructions for installing and wiring photocells, including connection diagrams for different models.
Explanation of photocell functions during opening/closing and their role in gate alignment.
Procedure for the auto-learning function of the gate opener system for proper movement and positioning.
Steps to pair a remote control for dual-gate operation by pressing the RF2 button on the PCBA.
Steps to pair a remote control for single-gate operation by pressing the RF1 button on the PCBA.
Details on remote control operation, including key functions and gate opening/closing sequences.
Explanation of the automatic closing feature, its timing, and operation after gate movement.
Instructions for operating the gate directly from buttons on the PCBA, mirroring remote control functions.
Procedure to erase all paired remote controls from the system's memory by pressing the 'Clear' button.
Steps to perform a system reset, clearing RF data and restoring default settings by pressing 'Clear'.
Guide to configuring gate opener system using dip switches for functions like auto-close and gate type.
Information on setting current limits via dip switches (4-6) to adjust motor sensitivity and protection.
Technical details of the V350 actuator, including voltage, power, weight capacity, speed, and protection rating.
Technical details of the GCG1-SWD2 control box, including input/output, RF frequency, and dimensions.
Statement of compliance with R&TTE, EMC, and Low Voltage directives, listing relevant standards for the V350 kit.
To Next Page
