SEM SSD2-HS - Page 42

508.366.1488 | www.semshred.com
42
Tools and PPE Required:
Cut resistant gloves
7/16” and 3/4” wrenches or sockets
1. De-energize the unit using proper lockout-tag out (LOTO) procedures.
2. Open the Stage 2 cutting chamber access door (front door). See Figure 54.
Figure 54. Inside Stage 2 cutting chamber access door
3. Using a ¾” socket wrench, remove the two painted side bolts that hold the cutting chamber drawer in
place. See Figure 55.
NOTE: Never operate the unit without these bolts in place.
Figure 55. Two painted side bolts to remove