Using the “Conference Manager” software
156 | ADN Digital Conference System
Loading a configuration
왘 In the menu bar, click “Global Menu” > “Open Conference...”.
The “Open”
window appears.
If the sof
tware is connected to a central unit (see page 154), you can load three
types of configurations:
Loading a configuration ...
Actions
... of an active (running)
conference
To load your configuration in “Live“
*
operating
mode:
왘 Select the “Open Active Conference Document
from CU” option button.
왘 Click “OK”.
T
o select the operating mode (“Setup”
**
or “Live”) in
which the configuration is to be loaded:
왘 Select the “Open Conference Document from CU”
option b
utton.
왘 Select the configuration of an active conference
(ma
r
ked with an asterisk “*”) from the drop-
down list.
왘 Select the operating mode (“Setup” or “Live”)
and c
lick “OK”.
* After loading a configuration, the conference automatically starts in “Live” operating
mode. Also observe the information on page 158.
** In “Setup” operating mode, you can adapt existing configurations to your needs.
... of a non-active
conference
To select the operating mode (“Setup” or “Live”) in
which the configuration is to be loaded:
왘 Select the “Open Conference Document from CU”
opti
on b
utton.
왘 Select the configuration of a non-active confer-
ence (not marked with an asterisk “*”) from the
d
rop-d
own list)
왘 Select the operating mode (“Setup” or “Live”)
and c
lick “OK”.
... of a conference saved
locally on the hard disk
***
*** Only available if you are using the Windows version of the software – even if there is no
connection to a central unit.
왘 Select the “Open Local Conference Document”
option button.
왘 Click “OK” and select the desired configuration
from the “Open Conference” file selection dialog
box (f
il
e extension “*.adn”).
왘 Click “OK”.
The confe
rence is loaded in “Setup” operating
mode.
If you open a configuration in “Setup” operating mode, the password set
will be prompted (where applies) (see page 152).
To Next Page
Loading...
