Putting the conference system into operation
42 | ADN Digital Conference System
Preparing the ADN-W AM antenna module for
operation
The antenna module is powered from the ADN CU1 central unit or the ADN PS
power supply via the SBC CBL RJ45 system cable.
Connecting the antennas
Always use all 3 antennas to ensure reliable wirel
ess operation. The 3 antennas are
already connected upon delivery.
왘 Connect the 3 antennas to the 3 antenna sockets.
왘 Screw down the 3 antenna coupling rings as shown.
The antennas are connected and secured.
If the power supplied via the system cable is not sufficient and if the
antenna module is not listed in the central unit‘s operating menu under
“System Menu” > “Versions” > “Hardware Version Info” or “Software
V
e
rsion Info”:
왘 Use the optional NT 12-50C power supply.
Software Version Info
Main Menu
System Menu
Versions
No
Hardware Version Info
CU1 SB: 1
ADN PS: 1
AM 1
CAUTION
Radio communication outside the legal requirements!
When connecting antennas other than the supplied ones, the transmission power
of the conference system may not meet the legal requirements and may cause
interference to other radio equipment.
왘 Only connect the supplied rod antennas t
o the antenna module.
6
7
To Next Page
Loading...
