Sennheiser ADN CU1 - Setting up the ADN-W C1 or ADN-W D1 Wireless Conference Units

Putting the conference system into operation
74 | ADN Digital Conference System
Setting up the ADN-W C1 or ADN-W D1 wireless
conference units
왘 Set up the devices so that there is a “free line of sight” between the ADN-W C1
or ADN-W D1 wireless conference units and the ADN-W AM antenna module.
왘 Configure the wireless components of the confer
ence
system (see page 81).
CAUTION
Danger of intermodulation!
If you
set up the ADN-W C1 or ADN-W D1 wireless conference units and the
ADN-W AM antenna module too close to one another, intermodulation can occur.
왘 Observe a minimum distance:
– of 1 m between the wireless conference units and the antenna module and
– of 0.5 m between the wireless conference units.
75
...
max. 50 m
ADN CU1
ADN-W AM
> 1 m
> 0.5 m
> 0.5 m
Transmission range approx. 30 m
> 0.5 m
ADN CU1
ESC
approx. 30 m
In some countries/regions (e.g. Canada), the use of wireless components
operating in the 5.15 to 5.25 GHz frequency band (channel 5 to 8) is
restricted to indoor use.