Putting the conference system into operation
40 | ADN Digital Conference System
Preparing the ADN PS power supply for operation
If you want to place the ADN PS power supply on a flat surface:
왘 Make sure that the air vents are not covered or blocked.
왘 Place the ADN PS power supply on a flat surface as shown.
CAUTION
Danger of material damage and personal injury due to stacked
pow
e
r supplies!
When stacking several ADN PS power supplies on top of each other,
• the stack may topple over,
• the temperature of the individual ADN PS power supplies may
drastically increase,
• high mechanical loading may be exerted on e.g. the housings,
cables or installation surfaces.
This can cause material damage and personal injury.
왘 Never stack several ADN PS power supplies on top of each other.
To Next Page
Loading...
