Sennheiser ADN CU1 - Updating the Firmware of the Conference System

Updating the firmware of the conference system
230 | ADN Digital Conference System
Updating the firmware of the
conference system
You can display the version numbers of the hardware and software via the central
unit’s operating menu (see page 111).
Information on the firmware update of the ADN products (“ADN System Update”)
c
an
be found in the “ADN System Software Setup” manual included on the DVD-
ROM (supplied with the central unit) or at www.sennheiser.com.
For further information on firmware updates for your ADN conference system, con-
tact your Sennheiser partner.
CAUTION
Danger of damage to the conference system!
Improper modification of the firmware (e.g. due to updates) can cause irreparable
damage to the conference system.
왘 Only update the firmware if the function of your conf
erence system is impaired
or if the update is recommended by Sennheiser.
왘 Contact your Sennheiser partner to update the firmware.
왘 While the update is in process, do not disconnect the ADN CU1 central unit, the
AD
N PS power supplies and the conference units from the mains power supply.
왘 Only update the firmware of the ADN-W D1 or ADN-W C1 wireless conference
units when a fully charged ADN-W BA battery pack is installed.