Sennheiser ADN CU1 - Page 46

ADN Digital Conference System |45
Putting the conference system into operation
왘 Hold the conference units with one hand so that the microphone does not rest
on the table.
왘 Insert the cable holder as shown.
At this point, the cable holder is not yet fixed with screws. You first have to
connect the conference units as described in the chapter “Setting up the con-
ference system” on page 56.
After you have correctly connected and installed all conference units:
왘 Choose a suitable cover for the cable holder :
왘 Affix the covers as shown.
왘 Slightly tighten the supplied screws (approx. 0.05 Nm).
IN OUT
B
B
B
C
B
C
Cable Cable holder cover
SDC CBL RJ 45 system cable marked “M”
Highly shielded cable marked “L”
IN OUT
B
C
IN OUT
C
D
C
D