ADN Digital Conference System |47
Putting the conference system into operation
Inserting/removing the battery pack
To insert the ADN-W BA battery pack into the wireless conference unit:
왘 Check the battery pack before using it in order to
ensure sufficient battery
capacity and to exclude a defective battery pack (see page 51).
왘 Charge the battery pack if necessary (see page 51).
왘 Slide the battery pack into the battery gu
id
e rails of the wireless conference
unit.
The battery release clip
locks into place with an audible click and secures the
battery pack.
To remove the battery pack from the wirel
ess conference unit:
왘 Press the battery release clip
and pull the battery pack out of the battery
guide rails.
To Next Page
Loading...
