Sennheiser TR 195 - Personal Hearing: Volume Levels; Pairing Headphones

Using the RS 195
24 | RS 195
b Press the MODE/LEVEL button on the transmitter for 2 seconds
until the
Personal Hearing LEDs indicate the desired function.
*from product version 06/2017
Pairing one or two pairs of headphones with the
transmitter
The headphones and the transmitter of your RS 195 headphone sys-
tem are factory pre-paired. The following procedure is only neces-
sary if you have cleared all pairing settings from your wireless head-
phone system and want to re-establish the pairing, or if you want to
pair another pair of headphones with the transmitter.
You can simultaneously connect up to 2 paired headphones to your
TR
195 transmitter. However, if a second pair of HDR 195 head-
phones is connected to the transmitter, you cannot make use of the
hearing profiles in order to improve the listening situation. The hear
-
ing profiles can only be used with one pair of HDR 195 headphones.
b Place the headphones on the headphone holder of the transmitter
for one second.
The Charge status LED on the transmitter lights up red. The
headphones are paired with the transmitter.
2s
MO
D
E
/LEV
E
L
Personal Hearing LEDs Setting
LED lights up
Standard volume
The maximum possible volume is
optimally adapted to the hearing
profiles A-G. Compared to
Normal
Hearing
, however, the volume is
reduced in order to protect your
hearing.
LED flashes 3x and
then lights up
High volume
The maximum possible volume is
increased if you are using one of the
hearing profiles A-G.
Only use this setting if the standard
setting is not sufficient.
No LED lights up
Normal Hearing is activated, the
maximum possible volume is not
limited.
It might also be that one of the LEDs indicating sound optimi-
zation for speech or music listening lights up (see page 23).
3x